• Features new peak 14mm longer, 5mm wider than VX-PRO 3
• Larger relief ports to allow more air to escape from under the larger peak to minimize lift/pulling at speed
• New chin vent incorporates expanded SS mesh moved from inside to outside of shell, provides room to move the EPS chin liner forward for more room in the face area
• Chin vent has mesh cap, round and smooth to resist snagging and digging in, easily removable with single screw and will break away if necessary in an impact
• Inner Mud Gate that can be easily removed for more airflow
• New Liner components features FCS cheek pads that have a larger surface area, wrapping under jaw for more comfort like our street helmets
• New removable, replaceable, washable neck roll pad
• 5mm peel away cheek pads and temple pads
• New red and black material accent colors for a tri-color interior
• New Emergency Cheek Pad Removal strap label design for easier use – label acts as pull tab for strap
• New ventilation consists of additional top vent hole, increasing from five to six upper vents
• New upper and lower rear exhaust vent cowl design to increase airflow and vacuum exhaust
• Vents designed to assist holding goggle strap in center position and not slide off, up or down
• Upper rear exhaust vent set design to accommodate all five shell sizes
• New vent design still fragile under crash impact, but seems more durable against smaller contact
• Same three basic chin intakes, two under peak intakes, six upper exhaust and two lower exhaust
• New eye-port trim and material has molded rubber trim across top of eye port, with standoff ribs, that resist goggles wearing the helmet liner as well as providing small gap for airflow
• Molded goggle strap guides at either side of eye port trim
